Cisco 7935 System Manual page 49

Chapter 40 Cisco IP Phones
Table 40-6 Phone Configuration Checklist (continued)
Configuration Steps
Step 5
Configure Cisco IP Phone services.
You can configure services for Cisco IP Phone models
7970, 7960, 7940, 7912, 7905, and Cisco IP
Communicator if you want to provide services for users
or if you are configuring phones that do not have a
specific user who is assigned to them. Users can change
the services on their phones by using the Cisco IP Phone
User Options.
Step 6 Customize phone button templates and softkey templates,
if required. Configure templates for each phone.
Step 7 Assign services to phone buttons, if required.
Step 8 Provide power, install, verify network connectivity, and
configure network settings for the Cisco IP Phone.
Step 9 Associate user with the phone (if required).
Step 10
Make calls with the Cisco IP Phone.
OL-7135-01
Phone Configuration Checklist
Procedures and Related Topics
Configuring Cisco IP
Cisco CallManager
Administration Guide
Adding Phone Button
Templates, Cisco CallManager
Administration Guide
Configuring Cisco IP
Cisco CallManager
Administration Guide
Adding Nonstandard Softkey
Templates, Cisco CallManager
Administration Guide
Adding a Cisco IP Phone
Service to a Phone
Cisco CallManager
Administration Guide
Cisco IP Phone Administration
Guide for Cisco CallManager
Associating Devices to a
Cisco CallManager
Administration Guide
Refer to the user guide for your
Cisco IP Phone.
Cisco CallManager System Guide
Phones,
Phones,
Button,
User,
40-49