Table of Contents
Advertisement
Removing the removable shelves
The removable shelves can be extracted from
the interior of the wine cellar to facilitate
cleaning.
Removing the removable shelves
1. Open the door.
2. Pull the shelf out.
3. Remove any bottles present.
4. Lift the shelf removed upwards.
5. Position the shelf correctly again on the
guides.
Push-pull mechanism (on some
models only)
If it is necessary to adjust the push-pull
mechanism to optimise door opening/ closing:
1. Open the door
2. Turn the push-pull mechanism pin right/left.
3. Close the door and check that it is closed
correctly.
INSTALLATION
Electrical connection
See General safety instructions.
General information
16 - INSTALLATION
4. If necessary, repeat the adjustment.
What to do if...
The appliance does not work:
• Make sure that the appliance is plugged in
and that the main switch is turned on.
The compressor starts to function too often or
functions continuously:
• The room temperature is too high.
• The door is being opened too often or for
too long.
• The door is not closing/sealing properly.
• There is an excessive quantity of non-cooled
bottles.
There is excessive condensate build-up inside
the wine cellar:
• The door is being opened too often or for
too long.
• Warm bottles have been placed inside the
wine cellar.
• The door seal is damaged or dirty. Clean or
replace it.
Water builds up inside the wine cellar:
• The drainage channel or opening is
blocked.
The wine cellar cooling is insufficient:
• The temperature set on the display is too
high.
• The door is being opened too often or for
too long.
• The door is not closing/sealing properly.
• The room temperature is too high.
• Check the mains characteristics against the
data indicated on the plate. The
identification plate bearing the technical
data, serial number and brand name is
visibly positioned inside the appliance. Do
91477A491/A
Advertisement
Table of Contents
