Networking Your Studiolive Ai Loudspeaker - PRESONUS SL-Dante-SPK User Manual

2

Networking Your StudioLive AI Loudspeaker

2.1 Step 1: Installing the SL-Dante-SPK
2 Networking Your StudioLive AI Loudspeaker
Step 1: Installing the SL-Dante-SPK
2.1
Your SL-Dante-SPK option card allows any StudioLive AI-series loudspeaker in which
it's installed to connect to a Dante network using an Ethernet cable. It is important
to mention that once the SL-Dante-SPK option card is installed, you can no longer
wirelessly control your loudspeaker using the USB Wi-Fi LAN adapter. All control must
be done over Ethernet, even when not connected to a Dante network.
1. Using a Phillips screwdriver, remove the three screws in the bottom and the center
screw in the top of the SL-Control-SPK option card that came installed in your
loudspeaker. Retain these screws.
2. Loosen the two thumbscrews at the top of the SL-Control-SPK option card.
3. Gently pull the SL-Control-SPK card straight out and then slide down to remove it.
SL-Dante-SPK
User Guide
2