3.
After the Power Pod has been completely removed, remove the four- (4)
processor retaining nuts from the retaining studs at the base of the Intel
Itanium™ processor. Set them safely aside.
4. Grasping the heat sink on the processor, while depressing firmly on the black
processor ejector tab, gently rock the processor side-to-side until freed from the
LIF socket. Refer to Figure 9.
16
Slide the Pod in this
direction to remove.
CAUTION: DO NOT LIFT the Pod until completely
disengaged from the processor, or damage to the processor
power connector may result.
Figure 8. Removing the Power Pod
Figure 9. Removing the Processor
hp workstation i2000
Rock gently side to
side until free
Press down on
the processor
ejector tab.