Compaq Deskpro EX User Manual page 33

7. Remove the drive from the drive adapter by first removing the four screws that connect
the drive to the adapter, and then sliding the drive out of the adapter.
To install a side-mounted hard drive, reverse the above procedure.
When installing the drive adapter into the computer, the slots in the bottom of the
adapter must be lined up with the tabs in the chassis.
CAUTION: When servicing the computer, ensure that cables are placed in their proper locations
during the reassembly process. Improper cable placement can damage the computer.
CAUTION: Use only 3/16-inch or 5-mm long screws as guide screws. Longer screws can damage
the internal components of the drive.
The system automatically recognizes hard drives sold by Compaq (or any other Plug and
Play hard drive) and will automatically reconfigure the computer. If you installed a third-
party hard drive, or one that is not a Plug and Play device, you must run Computer Setup
to reconfigure the computer.
Compaq Deskpro EX Series of Personal Computers 4-9