Advertisement
OPERATION
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Operating Positions (Figure 3)
NOTE: There are three operating positions: straight, left,
and right.
1. Pull up the latch pin.
2. Swing the blade to one of the operating positions.
3. Replace the latch pin.
Latch Pin
Latch Pin
Latch Pin
Straight
Left
Right
Figure 3
Operation
1. Select the operation position.
2. Start the unit moving forward slowly and select the
speed that is appropriate for the conditions.
MAINTENANCE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
Gravely Dealers will provide any service or adjustments
which may be required to keep your unit operating at
peak efficiency.
Interval
Task
Check
Fasteners
Clean
Blade
Each
Oil Latch
Use
Pin and
Pivot Pin
Check
Scraper
Blade
STORAGE
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
IMPORTANT: NEVER spray unit with high-pressure
water. DO NOT store unit outdoors.
Clean plastic surfaces with sponge and mild detergent.
Dry with a soft cloth.
Remove all dirt, grease, etc. from unit.
Store in a clean, dry area.
Ensure all fasteners are properly tightened. Inspect
moving parts for damage and wear.
Touch up all rusted or chipped painted surfaces.
9
Action
Ensure all hardware is tight. Pay
special attention to the guards
and safety shields.
Clean the blade after each use.
Apply a light coat of oil to latch
pin and pivot pin
Check the condition of the
scraper blade. Replace the
scraper blade when the it has
worn down by the blade.
Advertisement
