Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for NEO PIZZA-GAS-12
- Page 1 MANUAL & SAFETY INSTRUCTIONS PIZZA-GAS-12...
- Page 2 Please read the safety manual carefully before using the appliance. Do not store spare LP-gas under or near the appliance. Never fill the cylinder beyond 80 percent full. Lighting instructions: If the information beyond is not followed exactly, a fire causing death or serious o Make sure the control knob is in injury may occur.
- Page 3 SAFETY PRACTICES TO AVOID The parts which have been sealed by the manufacturer should not be adjusted by the user. INJURY When the appliance is using LPG a LPG cylinder When properly cared for, your oven will provide should be used. a safe, reliable service for years.
-
Page 4: Parts List
PARTS LIST 1. Neo Gas Pizza Oven 2. Stone Baking Board ASSEMBLY Before assembly, please make sure all parts are present. If any part is missing or damaged, do not attempt to assemble the appliance. Contact customer service for replacement parts. - Page 5 3.Connecting gas hose to Neo Gas Pizza Oven Depending on your region the hose may be pre-assembled. 3a. Connecting gas hose directly to Neo Gas Pizza Oven 3b i). Connecting barb to Neo Gas Pizza Oven This is a push on gas fitting. Please ensure that the black switch is in the horizontal position.
- Page 6 CONNECTING THE LIQUID PROPANE GAS CYLINDER To connect the liquid propane gas cylinder: 1. The cylinder valve should be in OFF position. 2. Also make sure the burner valve is in OFF position. 3. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage.
-
Page 7: Before Testing
Wait for Neo Gas Pizza Oven to cool completely before moving. The outer shell of the Neo Gas Pizza Oven may fade over time and through use. This will not affect performance. Stone baking board DO NOT use the stone over an open flame. -
Page 8: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Prevention/Solution 1. Check to see if propane tank is empty 1. No gas flow 2. Turn the coupling nut about one-half 2. Coupling nut and regulator not to three quarters additional turn until fully connected solid stop. Tighten by hand only – do Burner will not light 3.