Canon PIXMA MP210 Series Setup Instructions

Q T 5 1 2 0 6 V 0 1
Unpack the Machine • Please confirm the included items against the illustration printed on the lid of the packing box.
• A USB cable is necessary to connect the machine with your computer.
1
Prepare the Machine
Important
When moving the machine, carry the machine at both ends as shown below. Do
not lift the machine by grasping the Paper Support Extension.
a Place the machine on a flat and horizontal surface, and do not
place any objects in front of the machine.
Remove all the shipping tapes and protective material on the outside of the
machine.
Then open the Paper Output Tray.
Lift the Scanning Unit (Printer Cover), and pull the Scanning Unit
b
Support down into place.
Scanning Unit (Printer Cover)
c Remove the protective material on the right side.
Protective Material
Caution
Before turning on the machine, remove all of the shipping tapes.

Start Here

Easy Setup Instructions
d Lift the Scanning Unit (Printer Cover) slightly to set the Scanning
Unit Support back to its original position, and then gently close
the Scanning Unit (Printer Cover).
e Plug the power cord in the back of the machine and connect the
other end to the wall outlet.
Document Cover
Power Cord
Important
Make sure that the Document Cover is closed.
Note
Do NOT connect the USB cable at this stage.
f Press the ON/OFF button to turn on the machine. The machine
will initialize. Wait until the Power lamp stops flashing and
remains lit green.
Lift the Scanning Unit (Printer Cover), and pull the Scanning
g
Unit Support down into place. The FINE Cartridge Holder
automatically moves to the left.
Scanning Unit (Printer Cover)
h Write down the serial number located inside the machine. You
will need this to register your product.
Serial Number
Important
When cleaning the exterior of the machine, use a soft cloth to wipe it gently. For details, refer to "Cleaning Your Machine" in the Quick Start Guide.
2

Install the FINE Cartridges

a Remove the Black FINE Cartridge from its box.
Remove the protective tape gently.
b
Protective Tape
Electrical Contacts
Print Head Nozzles
Important
• Do not touch the electrical contacts or Print Head Nozzles on a FINE Cartridge.
The machine may not print out properly if you touch it.
• Do not reattach the protective tape once you have removed it.
• Be careful not to stain your hands or surrounding work area with ink on the
removed protective tape.
c Insert the Black FINE Cartridge slightly slanted into the left slot
.
B
Photo All-in-One
d Push up the FINE Cartridge until it clicks into place.
Important
For correct machine operation, make sure the FINE Cartridge is securely inserted.
Click
e Repeat the procedure for the Color FINE Cartridge, inserting it
into the right slot .
C
Lift the Scanning Unit (Printer Cover) slightly to set the Scanning
f
Unit Support back to its original position, and then gently close
the Scanning Unit (Printer Cover).
Important
Once you have installed the FINE Cartridges, the LED will flash green. Wait until
the LED stops flashing and displays 1. It takes about one to two minutes.
Hardware setup is complete.