2 and 4.5 kW heaters, chains can be attached to the four holes in the corners of the back reflector. (Chromalox offers hanging chain kits for these heaters that will allow for instal- lations 2 to 6 feet from the ceiling.) Minimum spacings:...
8. Connect entrance wiring to pigtail leads “L1” and “L2”. Connect ground to screw provided. 9. Inspect to make sure wiring is per “Single Phase Wiring” above. Chromalox STAR series radiant heaters can be field modified by adding optional kits. Refer to Chart A to select the proper kit.
7. Remove bulkhead fitting nuts and washers. 8. Remove failed element and replace with a new element. Replace only with genuine Chromalox "Arctic End" elements. Use of other elements will cause excess temperatures inside terminal box. 9. Place gasket on the bulkhead fitting and insert terminals and fit- tings into the element holes in the terminal box.
Page 6
Limited Warranty: Please refer to the Chromalox limited warranty applicable to this product at http://www.chromalox.com/customer-service/policies/termsofsale.aspx. 2150 N. RULON WHITE BLVD., OGDEN, UT 84404 Phone: 1-800-368-2493 www.chromalox.com...
This manual is also suitable for:
Star pg434-4Star-02a-11-fStar-02a-81-fStar-02a-21-fStar-02a-71-fStar-02a-41-f...
Show all