Yamaha YZ250 Owner's Service Manual page 221

INSTALLING THE SPRING (REAR SHOCK
ABSORBER)
1. Install:
• Spring "1"
• Upper spring guide "2"
• Lower spring guide "3"
2. Tighten:
• Adjuster "1"
3. Adjust:
• Spring length (installed)
Refer to "ADJUSTING THE REAR SHOCK
ABSORBER SPRING PRELOAD" section in
the CHAPTER 3.
4. Tighten:
• Locknut "1"
Downloaded from ManualsNet.com search engine
REAR SHOCK ABSORBER
INSTALLING THE REAR SHOCK
ABSORBER
1. Install:
• Dust seal "1"
• O-ring "2"
• Collar "3"
• Apply the molybdenum disulfide grease on
the dust seal lips and collars.
• Apply the lithium soap base grease on the O-
rings.
2. Install:
• Bushing "1"
• Collar "2"
• Dust seal "3"
• Apply the molybdenum disulfide grease on
the bearing and dust seal lips.
• Install the dust seals with their lips facing out-
ward.
3. Install:
• Rear shock absorber
5-59