Disassembly Of The Set - Sharp LC-12A2E Service Manual

LC-12A2E
1. Insert your finger into the center of the terminal cover
and pull it toward you to detach the terminal cover.
2. Remove the four screws 1 and one screw 2.
3. Open the cabinet B by approx. 45˚ from the bottom
of the cabinet (stand side).
4. Remove the lead wire from the cable clamp 3.
5. Remove the power connector 4.
6. Remove the connector 5 from the light reception
unit.
7. Remove the lead wire from the cable clamp 6.
8. Remove the speaker connector 7.
9. Remove the FFC from the FFC connector 8 on the
main PWB.
10. Remove the connector 9 from the ir unit.
11. Remove the connector 0 from the switch PWB.
12. Remove the right and left speaker connectors q
on the terminal PWB.
Terminal Cover
Hinge Cover
Rotation Cover

DISASSEMBLY OF THE SET

GCOVA1855CEKB
GCOVA1853CESA
GCOVA1854CESA
<<Disassembly of the main PWB>>
1. Disconnect the flexible cable connectors w and
e from the LCD panel.
2. Disconnect the cable connectors r and t from
the fluorescent lamp.
3. Remove the four screws y.
<<Disassembly of the terminal PWB>>
1. Remove the cover i.
2. Remove the five screws u.
3. Remove the two screws o. Take them out of the
cabinet holes.
<<Cabinet A side>>
Cabinet A GCABA2401CEKB
<<Cabinet B side>>
Cabinet B GCABB2295CEKA
6