Installing and Removing the SD Card
The captured image is recorded onto the card (sold separately).
Make sure the card's write protect switch is set upward to
enable writing/erasing.
Installing the Card
Card's write
protect switch
Shots remaining
The number of shots remaining depends on the remaining capacity of
the card, image-recording quality, ISO speed, etc.
Setting the [1 Release shutter without card] menu option to [Disable]
will prevent you from forgetting to install a card (p.130).
Open the cover.
1
Slide the cover as shown by the
arrow to open it.
Insert the card.
2
As shown by the illustration, face
the card's label side toward you
and insert it until it clicks in place.
Close the cover.
3
Close the cover and slide it in the
direction shown by the arrow until it
snaps shut.
When you set the power switch to
<1>, the number of remaining
shots will be displayed on the LCD
monitor.
31