Table of Contents
Advertisement
[4] OPERATION, DISPLAY SECTION
1. Operation panel
No.
Name
1
Touch panel
2
Mode select keys
3
LINE light
4
Numeric keys
5
[CLEAR] key
6
[FAX] key
7
[JOB STATUS] key
8
DATA light
9
[CUSTOM SETTINGS] key Use to customize the machine settings to better suit your needs. When using the fax function, destinations can
10
[ACC.#-C] key
11
[START] key
12
[CLEAR ALL] key
2. FAX mode (Condition setting screen)
The condition setting screen of fax mode is displayed by pressing the [FAX] key while the print mode, copy mode, or job status screen appears in the
touch panel. In the explanations that follow, it is assumed that the initial screen that appears after pressing the [FAX] key is the condition setting
screen (shown below). If you have set the display to show the address directory when the [FAX] key is pressed, touch the [CONDITION SETTINGS]
key in the address directory to display the condition setting screen.
A key operator program can be used to set the display to show either the condition setting screen (shown below) or the address directory screen (p.8)
when the [FAX] key is pressed.
A. Condition setting screen
The display is initially set (factory setting) to show the following screen when the [FAX] key is pressed.
1
• Messages and keys appears in the touch panel.
A key can be touched to select or enter a setting.
• When you touch a key, a beep sounds and the key is highlighted to indicate that it has been selected.
• Keys that cannot be selected in a screen are grayed out. If a grayed out key is touched, a double beep will
sound to indicate that the key cannot be selected.
Use to select the basic modes of the machine.
This lights while a fax is being sent or received.
Use for settings that require the entry of numbers.
This is used to clear a mistake when entering a number. One digit is cleared each time the key is pressed. The
key is also used to cancel scanning of an original.
Press to switch to fax mode. The initial screen of fax mode will appear in the touch panel display.
Use to check the status of a job.
This light blinks when a fax has been received to memory.
The light stays on constantly when a fax is waiting in memory for transmission.
be stored and settings for fax reception and fax forwarding can be selected.
Press to use the fax function when auditing mode is enabled. This key can also be used to issue tone signals
when the machine is connected to a pulse dial line.
Press to begin scanning an original for fax transmission.
Use to cancel a transmission or programming operation. When the key is pressed, the operation is canceled
and you return to the initial screen.
When sending a fax, this key is also used to cancel an image setting, paper size setting, or special function.
1
READY TO SEND.
14
AUTO
13
EXPOSURE
STANDARD
12
RESOLUTION
11
AUTO
ORIGINAL
10
AR-FX7 ADJUSTMENTS 4 - 1
2
3
4
COPY
ON LINE
PRINT
DATA
SCAN
DATA
LINE
FAX
DATA
JOB STATUS
CUSTOM SETTINGS
ACC.#-C
6
7
8
9
10
Function, operation
2
3
4
SPEAKER
REDIAL
FAX MEMORY:100%
ADDRESS
AUTO RECEPTION
BOOK
SUB ADDRESS
SPECIAL MODES
ADDRESS REVIEW
DIRECT TX
MEMORY TX
9
5
11
12
5
6
7
8
Advertisement
Table of Contents
