Installing The Driver Software - Sony PCWA-C100 Owner's Manual

Wireless lan pc card

Hide thumbs Also See for PCWA-C100:

Table of Contents

Getting started

Installing the driver software

Install the driver software for the Wireless LAN PC Card. The installation procedure requires the availability

of a CD-ROM drive when the Wireless LAN PC Card is inserted.

If your computer has two PC Card slots and your CD-ROM drive must be connected through one of them,

connect the CD-ROM drive to the bottom slot.

If your computer has only one PC Card slot, and your CD-ROM drive must be connected through it, copy the

Wireless LAN folder from the supplied CD-ROM into the hard disk before inserting the Wireless LAN PC Card.

The following steps use C:\Temp folder as an example. If you can use the CD-ROM drive while the Wireless

LAN PC Card is inserted, the following steps are not required. Begin installation starting from step 1.

Connect the CD-ROM drive to the computer and insert the supplied CD-ROM into the drive.

Create a Temp folder on the C: drive using Window Explorer.

Copy the Wireless LAN folder in the CD-ROM to C:\Temp folder.

Remove the CD-ROM drive connector from the PC Card slot, then proceed to step 2.

If you need more help on how to remove the CD-ROM drive, please refer to the Removing the Wireless

LAN PC Card

To install the driver when using Windows

Insert the supplied CD-ROM into the CD-ROM drive.

Insert the Wireless LAN PC Card into the PC Card slot.

The Add New Hardware Wizard screen appears.

Click Next.

Make sure that the Find an appropriate driver for a device in use check box is selected, and then

click Next.

Select Specify a location, then click Browse.

Select the folder containing the driver, then click OK.

(page 14)

section, as both accessories use the same approach.

98 Second Edition, proceed as follows:

n N

Table of Contents