Accessories Installation - Rinnai REI-E380NP-B-WH Instructions For Use, Installation, And Connection

HEATER UNIT INSTALLATION
HEATER UNIT INSTALLATION DIAGRAM
Washer
Screw A
Fig. 1
1. Select a suitable position in the bathroom. (Fig. 1)
2. Pull out the Temperature Control Knob and then remove the screw (A) at the bottom
of the unit.
3. Remove the Front Cover from the bottom and then lift up the front cover.
4. Mark 3 Screw points of the Heater Base on the wall. The Heater position should be
1.5m above the bathroom floor.
5. Use 6mm diameter drill and make the wall plug holes in depth of 34mm.
6. Insert the wall plugs and mount the Heater firmly in position with the screws provided.
5
262mm
165mm
Washer

ACCESSORIES INSTALLATION

Fig. 2
1. Make the 2 screws points of the bracket holder beside the heater. It is recommended the
top of the portion is in level with the top of the water heater. (Fig. 2)
2. Use 6mm diameter drill and make the wall plug holes (5 holes) to 34mm depth.
3. Insert the wall plugs and mount the heater firmly in position with the 3 screws provided.
1 2
1. Mark 2 screw points of the Shower Holder beside the Instant Hot Shower. It is
recommended that the top of the portion is in level with the top of Heater Unit.
2. Use 6mm diameter drill and make the wall plug holes in depth of 34mm.
3. Remove the cap from the Upper Rail Support, screw the bracket to position.
Replace the cap.
4. Insert the Shower Holder and Lower Rail Support into the Slider Rail. Put it into the
Upper Rail Support.
5. Remove the cap from the Lower Rail Support, screw the bracket to position.
Replace the cap.
3
6