Page 1
MODELS: REI-E380NP-B-WH REI-E380DP-C-BL REI-E380DP-B-WH REI-E380NP-C-TQ REI-E380DP-C-TQ REI-E380NP-C-BG REI-E380DP-C-BG REI-E380NP-C-BL Electric Instant Water Heater Instructions for use, installation, and connection innai (Malaysia) Sdn Bhd D2-3, Block D2, Pusat Perdagangan Dana 1, Jalan PJU 1 A/46, PJU 1 A, Ara Daman sara, 47301 Petaling Jaya, Selangor Darul Ehsan, Malaysia.
Page 2
PART CONTENTS CHECKLIST PART CONTENTS CHECKLIST MODEL: MODEL: Shower rail accessories Shower bracket accessories 1 x Rinnai Heater Unit 1 x Rinnai Heater Unit 1 x PVC hose 1.5m 1 x Sliding Rail 3 x Washers 1 x Shower Holder...
PARTS DESCRIPTION IMPORTANT SAFETY INFORMATION WARNING ! Products manufactured by us are safe provided they are installed, used and maintained in good working order in accordance with our instructions and recommendations. Always refer to this manual if you have any doubt. The appliance must be earthed.
HEATER UNIT INSTALLATION ACCESSORIES INSTALLATION HEATER UNIT INSTALLATION DIAGRAM 262mm Fig. 2 1. Make the 2 screws points of the bracket holder beside the heater. It is recommended the 165mm top of the portion is in level with the top of the water heater. (Fig. 2) Washer Washer 2.
PLUMBING PROCEDURE continue from ‘ELECTRICAL INSTALLATION’ CAUTION ! PROCEDURE: This Electric Instant Water H eater is a single point system and the “ Water Outlet ” can only be fitted to the PVC Hose and Handshower set provided. NO CONTROL VALVE OR FITTING Insert the wall embedded cable through Side Entry ‘B’...
TABLE 1 - ELECTRICAL LOADING TABLE HANDSHOWER SPRAY Minimum Conductor Size (csa) This Innovative adjustable Handshower has di erent spray patterns. (Fig. 7) Voltage Power Current On/O Fuse/ The patterns are described as following: Flexible Cable Switch (A) MCB (A) (AC) (kW) mm²...
TROUBLESHOOTING WIRING DIAGRAM WIRING DIAGRAM - WITH DOUBLE POLE ELCB, DOUBLE ACTION THERMOSTAT Troubleshooting Guide NO PUMP MODEL Symptom Possible Cause Remedy 1. The unit does not A. No electric current flow A. Check the connection operate. through the unit. of the wire if it’s fitted to the correct terminals.
Page 8
ELECTRICAL SPECIFICATION WIRING DIAGRAM TYPE ELECTRICAL POWER CONTROL ELECTRICAL LOADING 3.8kW 240V a.c. 50/60Hz Min. WATER FLOW RATE 2 Litre / min Min. INL ET WATER PRESSURE 0.2 Bar (20kPa) Max. INLET WATER PRESSURE 6 Bar (0.6MPa) WATER CONNECTION 1/2” BSP SINGLE POINT SYSTEM DIMENSIONS 388 x 222 x 129 mm 1.45 kg (No Pump)
This manual is also suitable for:
Rei-e380dp-b-whRei-e380np-c-bgRei-e380dp-c-bgRei-e380np-c-blRei-e380dp-c-blRei-e380np-c-tq...
Show all