6 Replace the audio, data and power cables.
7 Replace the cover. Refer to page 44.
Installing a Drive in the Lower Expansion Bay
1 Remove the cover. Refer to page 44.
2 Remove the PC's front panel by simultaneously releasing the four lower clips.
3 Rotate the bottom part of the panel gently upwards until the whole panel can be
lifted off.
4 Lay the front panel on a flat surface beside the PC.
5 Remove the plastic masking plate from the front panel by prising the retaining tabs
open by hand.
rear of front panel
6 If the bay has a metal blanking plate, then break it off using a screwdriver.
7 Slide the drive in from the front of the computer.
8 Tighten the three screws that fasten the drive to the bay. You must fit these screws
in the holes that have "1" engraved alongside.
Installing an Expansion Bay Drive
57