Configuring Remote Control Id And Projector Id Settings; Using The Countdown Timer (Timer); Showing And Hiding The Countdown Timer - Casio XJ-F Series User Manual

Configuring Remote Control ID and Projector ID
Settings
The remote control ID and projector ID are numbers from 1 to 4. If the two IDs match, you will be able
to perform all projector operations from the remote controller. This function helps to avoid remote
control conflicts when there are multiple projectors (up to four) in the same area.
The initial factory default setting of both the remote control ID and projector ID is "All", which means
that the remote controller signal can be sent and received regardless of the ID of the sending/receiving
device.
The "Specify a remote control ID" operation in the table below can be performed on the remote
control unit only. This operation can be performed even if the projector is turned off. For the other
operations, first start image projection operation and then perform the operation.
To do this:
Specify a remote control ID While holding down the remote controller [ESC] key, press one of the keys below.
Specify a projector ID
Check the current remote
control ID and projector ID
settings

Using the Countdown Timer (TIMER)

The countdown timer displays a large timer in the center of the projected image.
Important!
 To use the countdown timer, change "Option Settings 2 3 Timer Type" (page 65) on the
Setup Menu to "Countdown". (The projector's initial default setting is "Countdown".)
 The following functions are disabled while the countdown timer is being projected: Auto
Projection Off (page 47), Auto Power Off (page 64).

Showing and Hiding the Countdown Timer

1.
To show the countdown timer, press the [TIMER] key.
 This will display the countdown timer on top of the current projected image.
2.
To hide the countdown timer, press the [TIMER] key again.
Perform this operation:
 [1], [2], [3], or [4]: Sets the number of the key you press as the remote control ID.
 [MENU]: Changes the remote control ID to "All".
1. Press the [MENU] key to display the setup menu.
2. Select "Option Settings 1", "Projector ID", and then press the [ENTER] key.
3. Use the [] and [] keys to select a number from 1 to 4 or select "All", and then
press the [ENTER] key.
While holding down the remote controller [ESC] key, press the [INPUT] key. This will
project the remote control ID and projector ID for about 10 seconds. The remote
control ID and projector ID shown by this operation may not match each other.
56