Operation; Starting Cold Engine - Echo PB-750 Operator's Manual

12
O
PERATION
• Provide all operators of this equipment with the Operator's Manual
and instructions for safe operation.
• Check unit for loose nuts, bolts and screws daily.
• Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.

STARTING COLD ENGINE

1. Move throttle lever (A) forward to idle position.Slide stop switch
(B) forward to run position.
2. Close Choke - Cold Start.
Move choke (C) up to "Cold Start" position (
3. Primer Bulb -Prime.
Pump primer bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4. Pull recoil starter handle (E) and engine should start.
5. Move choke (C) down to run position (
restart engine.
NOTE
If engine does not start after 5 pulls, repeat cold start procedures.
NOTE
Allow engine to warm up before use.
).
), and if necessary,
A
B
C
D
E