Table of Contents
Advertisement
Fault
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Cause
The water outlet hose is con-
nected too high.
Pump cover is not correctly
assembled.
Pump cover is not correctly
assembled.
You have not pressed Start/
Reload
.
The filter in the water inflow
is blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
Troubleshooting en
troubleshooting
→ "Resuming the programme when
the programme status is Rinse
Hold", Page 39
Install the water outlet hose at a
▶
maximum height of 1 metre.
→ "Technical specifications",
Page 70
Correctly assemble the pump
▶
cover.
Correctly assemble the pump
▶
cover.
Press Start/Reload
▶
"Clean the water inflow filter"
▶
→ Page 53.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
.
59
Advertisement
Table of Contents
