Fcc, Acta And Ic Regulations - VTech CS6719-27 User Manual

FCC, ACTA and IC regulations

FCC Part 15
This equipment has been tested and
found to comply with the requirements
for a Class B digital device under Part
15 of the Federal Communications
Commission (FCC) rules. These
requirements are intended to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this
equipment not expressly approved by
the party responsible for compliance
could void the user's authority to operate
the equipment.
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation. Privacy of communications
may not be ensured when using this
telephone.
To ensure safety of users, the FCC has
established criteria for the amount of
radio frequency energy that can be
safely absorbed by a user or bystander
according to the intended usage of the
product. This product has been tested
and found to comply with the FCC
criteria. The handset may be safely held
against the ear of the user. The telephone
base shall be installed and used such
that parts of the user's body other than
the hands are maintained at a distance of
approximately 20 cm
(8 inches) or more.
This Class B digital apparatus complies
with Canadian requirement:
CAN ICES-3 (B)/NMB-3(B)
FCC Part 68 and ACTA
This equipment complies with Part
68 of the FCC rules and with technical
requirements adopted by the
Administrative Council for Terminal
Attachments (ACTA). The label on the back
or bottom of this equipment contains,
among other things, a product identifier
in the format US:AAAEQ##TXXXX. This
identifier must be provided to your
telephone service provider upon request.
The plug and jack used to connect this
equipment to premises wiring and the
telephone network must comply with
applicable Part 68 rules and technical
requirements adopted by ACTA. A
compliant telephone cord and modular
plug is provided with this product. It is
designed to be connected to a compatible
modular jack that is also compliant. An
RJ11 jack should normally be used for
connecting to a single line and an RJ14
jack for two lines. See the installation
30