Table of Contents
Advertisement
Important precautions concerning the
LCD Panel Assembly:
1. When you disassemble/re-assemble the Front
Cabinet or Function CBA Unit
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• When disassembling, first detach the hooks on each
end on the bottom side, then detach the remaining
hooks moving toward the center.
• Make sure the hooks are securely in place when
assembling.
• Be careful not to scratch the display panel when
assembling.
• Make sure the Function CBA Unit and Shield Plate
are securely in place when re-assembling.
• The screw tightening torque must be 5.2lb·in
(6kgf·cm).
[2] Stand Base Assembly
(S-4)
[1] Stand Neck Assembly
4-2
• After replacing the Front Cabinet or Function CBA
Unit, check the operational sensitivity of the touch
sensor to make sure it functions normally.
• Make sure to replace the Decoration Plate to a new
one when replacing the Front Cabinet.
2. When you disassemble/re-assemble the X-PCB
Cover
• Be careful not to break the hooks. If you pull with too
much force, the hooks may be damaged.
• When disassembling, first hold the top and bottom of
the X-PCB Cover on both ends and then moving
toward the center, lift up the top side to detach the
hooks.
• When assembling, be careful not to damage the
X-PCB Board or the COF(Chip On Film).
• Make sure the hooks are securely in place when
re-assembling.
• The screw tightening torque must be 5.2lb·in
(6kgf·cm).
[3] Rear Cover
(S-2)
(S-4)
(S-3)
(S-4)
(S-1)
Fig. D1
PL13.13_DC
Advertisement
Table of Contents
