Mitsubishi Electric Mr.SLIM PUZ-M200YKA.UK Service Manual page 113

15-5-3. PAR-SL100A-E
Fig. 15-1
Fig. 15-2
Fig. 15-3
Fig. 15-4
OCH737B
1. Going to the function select mode
Press the
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and ˝00˝ blinks. (Fig. 15-1)
Press the button to set the ˝50˝.
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
2. Setting the unit number
Press the button to set unit number A. (Fig. 15-2)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
A
3. Select a mode
Press the button to set Mode number B. (Fig. 15-3)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
Current setting number:
B
4. Selecting the setting number
Use the button to change the Setting number C. (Fig. 15-4)
Direct the wireless remote controller toward the receiver of the indoor unit
and press the
5. To select multiple functions continuously
Repeat select 3 and 4 to change multiple function settings continuously.
6. Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit
C
and press the
Note:
Make the above settings on Mr. Slim units as necessary.
• Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
113
button between of 5 seconds.
button.
button.
button.
1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
button.
button.