Printed Circuit Board F1 - Janome J30 Service Manual And Parts List

REPLACING THE ELECTRONIC COMPONENTS

PRINTED CIRCUIT BOARD F1

TO REMOVE:
1. Remove the front cover. (See page 6.)
2. Pull out connectors from the printed circuit board A.
3. Remove the screws (2 pcs.) and LED cover.
4. Remove the printed circuit board F2.
TO ATTACH:
1. Follow the above procedures in reverse.
NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect, grasp the connector, not the cord.
Connector (White) Printed circuit board F2
Setscrews
LED cover
27