Maintenance - Bosch DKE9465MUC Instructions For Use Manual

Buttons

Maintenance

Maintenance
Lights
Light Bulb Replacement
English 6
Remove the filter for replacement: Remove the aluminum filter and set aside.
Then remove the carbon filter. Push in on the latch in the front of the carbon filter.
Pull down and out. Dispose of filter.
Remove Carbon Filter
Install the replacement filter: Insert notches in holes on back wall of hood. Holding
the latch in, push front up into place. Release latch.
Wipe with sudsy water or household cleaners such as Fantastic
409  , rinse well and dry with a clean soft cloth to avoid water marks.
The following maintenance procedures can be performed without the aid of a ser-
vicer. Always contact a servicer for other repairs.
Use a 12V halogen bulb (max. 20Watt) with a two pin, G4 base.
NOTE: Turn off the lights and fan and allow lights to cool before handling. If lights do
not operate upon installation, check for proper insertion.
CAUTION: TURN POWER OFF AT BREAKER BEFORE REMOV-
ING A DAMAGED BULB. DO NOT TOUCH THE BULBS IMMEDI-
ATELY AFTER USE. THE BULBS WILL REMAIN HOT FOR
SEVERAL MINUTES.
Note: DO NOT touch a new halogen bulb with your fingertips. Grasp the bulb
through a clean paper towel or facial tissue. The oils from your skin can reduce
the longevity of the bulb.
Use a small flathead screwdriver (or your fingernail) to remove the lens.
Pull damaged bulb straight out from the socket to remove. Press pins in bulb base
straight into socket until fully seated. Snap lens back into place.
Install Carbon Filter
Figure 3: Carbon Filter
 or Formula
Figure 4: Light Bulb Replacement