Maintenance - Bosch DKE9665PUC Use And Care Manual

Maintenance

Maintenance
Lights
Light Bulb Replacement
English 6
The following maintenance procedures can be performed without the aid of a ser-
vicer. Always contact a servicer for other repairs.
Use a 12V halogen bulb (max. 20Watt) with a two pin, G4 base.
NOTE: Turn off the lights and fan and allow lights to cool before handling. If lights
do not operate upon installation, check for proper insertion.
CAUTION: TURN POWER OFF AT BREAKER BEFORE REMOV-
ING A DAMAGED BULB. DO NOT TOUCH THE BULBS IMMEDI-
ATELY AFTER USE. THE BULBS WILL REMAIN HOT FOR
SEVERAL MINUTES.
Note: DO NOT touch a new halogen bulb with your fingertips. Grasp the bulb
through a clean paper towel or facial tissue. The oils from your skin can reduce
the longevity of the bulb.
Use a small flathead screwdriver (or your fingernail) to remove the lens.
Pull damaged bulb straight out from the socket to remove. Press pins in bulb base
straight into socket until fully seated. Snap lens back into place.
Do not use cooktop while hood is disassembled, to ensure adequate ventilation.
Figure 4: Light Bulb Replacement