Start by Reading These Important Safety Rules These safety alert symbols mean WARNING – a personal safety or property damage instruction. Read these instructions carefully. This garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the following safety rules.
ASSEMBLY SECTION Install the Header Bracket Assemble Rail NOTE: Refer to vertical center and horizontal lines created in step Place Rail pieces (1) on a flat surface for assembly. Take special note of 11 for proper placement of header bracket. the raised line on the Rail pieces (4) these lines MUST line up in order for A.
Page 4
Connect Door Arm to Trolley Test the Safety Reverse System The safety reverse system test is important. Garage door must A. Preferred Installation: reverse on contact with a 40mm obstacle laid flat on the floor. Disconnect Trolley by pulling on the red handle and slide towards Failure to properly adjust opener may result in serious personal door.
HAVING A PROBLEM? Replace Light Bulb 1. Opener doesn’t operate from remote: Replace light bulb (1) with a 21 watt maximum light bulb. Insert bulb into • Does the opener have electric power? Plug lamp into outlet. If it doesn’t light, check the fuse box or the circuit breaker. (Some outlets socket (2) as shown.
D e c l a r a t i o n o f C o n f o r m i t y The undersigned, hereby declare that the equipment specified, and all accessories, conforms to the Directives and Standards stated. Model:...................PSGTA60 89/336/EEC 73/23/EEC...