LG LSN HSV4 Series Installation Manual page 21

Standard wall-mounted indoor unit
Table of Contents

Advertisement

F
MULTI
F
MULTI
MAX
Drilling Piping Hole in the Wall
Use caution when drilling holes through walls. Drilling into power wiring in the wall can
cause serious bodily injury or death.
Follow the left or right piping clearance recommendations in Figure 3 or Figure 4.
1. Using a 2-5/8 (ø 65mm) inch hole core drill bit, drill a hole at either the right or
left side of the wall mounting (Figure 6). The hole should slant 3/16" to 5/16" from
level (upward on the indoor unit side and downward on the outdoor unit side).
2. Finish off the newly drilled hole as shown with bushing and sleeve covering.
Sleeve and bushing prevents damage to the tubing/bundling of the piping.
Hanging the Indoor Unit Chassis
1. Attach the three (3) hooks on the top of the indoor unit to the top edge of
the installation plate. Verify the hooks are properly attached to the instal-
lation plate by gently shaking the indoor unit from side to side.
2. Unlock the tubing clamp from the indoor unit frame. For easier access be-
tween the bottom of the indoor unit and the wall, prop the clamp between
the indoor unit frame and installation plate.
3. Remove the screw covers at the bottom of the indoor unit, unscrew the
two (2) screws, remove the frame cover, remove the piping connection
cover, and position the piping for installation (down, back, left, or right).
Figure 8: Accessing the Back of the Indoor Unit.
Figure 10: Exterior Back View of Indoor Unit.
Right
Back
Down
GENERAL INSTALLATION GUIDELINES
Tubing Clamp
Figure 11: Piping Installed to the Left.
Tubing Clamp
Left
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Install Wall-Mounted IDU Chassis
Indoor
Core Drill
Bushing
Figure 7: Locking the Indoor Unit onto the Installation Plate.
Figure 9: Removing the Frame Cover.
Figure 12: Piping Installed to the Right.
Tape
Connecting
pipe
Drain hose
Figure 6: Drilling Piping Hole
WALL
Outdoor
Sleeve
Installation plate
Frame Cover
Tape
Connecting
pipe
Drain hose
21

Advertisement

Table of Contents
loading

Table of Contents