Getting To Know Your Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - Bosch PKN811E14E Instruction Manual

Getting to know your appliance

The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.

The control panel

# FKLOGSURRI ORFN
Controls
When you touch a symbol, the respective function is activated.

The hotplates

Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
Extended cooking zone
æ
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again

Residual heat indicator

The hob has a two-stage residual heat indicator for each
hotplate.

Setting the hob

This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.
To switch on: touch the #
indicator above the main switch lights up. The hob is ready for
use.
To switch off: touch the
#
main switch goes out. All hotplates are switched off. The
residual heat indicator remains on until the hotplates have
cooled down sufficiently.
&RQWURO IRU
– H[WHQGHG
FRRNLQJ ]RQH
&RQWURO IRU
PDLQ VZLWFK
Activating and deactivating
Touch the
Touch the
symbol. A signal sounds. The
symbol until the display above the
'LVSOD\V IRU
³É KHDW VHWWLQJ
‡¤ UHVLGXDO KHDW
 RSHUDWLQJ UHDGLQHVV
&RQWUROV IRU
KHDW VHWWLQJ DGMXVWPHQW
Notes
The settings will remain unchanged if you touch several
■
symbols at once. This allows you to wipe up spills on the
control panel.
Always keep the controls dry. Moisture reduces their
■
effectiveness.
ð symbol
symbol
æ
If appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to
cooled sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.

Setting a hotplate

Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
&RQWURO IRU
Í GXDOFLUFXLW KRWSODWH
© HOHFWURQLF ERLO VWDUW
FRQWURO
. The display remains lit until the hotplate has
œ
5