Table of Contents
Advertisement
A+ Server AS -1124US-TNRP User's Manual
2.3 Installing the Rails
There are a variety of rack units on the market, which may require a slightly different assembly
procedure. This rail set fits a rack between 25.6" and 33" deep.
The following is a basic guideline for installing the system into a rack with the rack mounting
hardware provided. You should also refer to the installation instructions that came with the
specific rack you are using.
If you are installing into a two-post "telco" rack, skip to that section later in this chapter.
Identifying the Rails
The chassis comes with two sets of rack rails, one set for the right side of the chassis and
one for the left. Each set consists of an inner rail that is
rail that attaches to the rack, and a middle rail that slides forward in the outer rail.
Middle Rail (not shown)--
slides forward from the
outer rail
Figure 2-1. Identifying the Sections of the Rack Rails
Note: Figure is for illustrative purposes only. Your system might look slightly different.
pre-attached
Inner Rail--
pre-attached to
the chassis
20
to the chassis, an outer
Outer Rail,
Front and Rear
Brackets
Advertisement
Table of Contents
