Table of Contents
Advertisement
◦ Image data edited or processed on a computer must be printed from the computer.
Note
When a photo which has been processed on a computer is selected, "?" is displayed on the
printer's touch screen.
• Cannot connect to the server. Please wait a while and try again.
The printer cannot connect to the server due to a communication error.
Select OK on the printer's touch screen to cancel the error and try again after a while.
Error Regarding Automatic Duplex Printing Is Displayed
See Automatic Duplex Printing Problems and take the appropriate action.
Check
Error Regarding Power Cord Being Unplugged Is Displayed (Windows)
The printer may have been unplugged while it was on.
Check the error message that appears on the computer and click OK.
The printer starts printing.
See
Unplugging the Printer
Writing Error/Output Error/Communication Error (Windows)
If the ON lamp is off, make sure printer is plugged in and turn on.
Check1
The ON lamp flashes while the printer is initializing. Wait until the ON lamp stops flashing and remains lit.
Make sure printer is properly connected to computer.
Check2
If you are using a USB cable, make sure it is securely connected to both the printer and the computer. When
the USB cable is securely plugged in, check the following:
• If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the
computer, and retry the printing. If printing starts normally, there is a problem with the relay device.
Contact the vendor of the relay device.
• There could also be a problem with the USB cable. Replace the USB cable and retry the printing.
If you use the printer over a LAN, make sure the printer is correctly set up for network use.
Make sure MP Drivers are installed correctly.
Check3
Uninstall the MP Drivers following the procedure described in Deleting the Unnecessary MP Drivers and click
here to reinstall them.
When printer is connected to your computer with a USB cable, check device
Check4
status from your computer.
Follow the procedure below to check the device status.
to unplug the printer correctly.
352
Advertisement
Table of Contents
