Table of Contents
Advertisement
discharge is completed within 2 minutes
and your machine will sound an audible
warning when it is completed.
Detergent or rinse aid may remain
inside the machine and/or the dishes
being washed as per the step of the
program you have cancelled.
Low Salt Warning indicator (
Check the low salt warning indicator on the
display to determine if the softening salt
available in your machine is adequate. You
shall add salt to the salt compartment when
the low salt warning indicator on the display
starts to illuminate.
Setting of water hardness level is
described in the Water Softening
System section.
Low Rinse Aid Warning indicator
( )
Check the low rinse aid warning indicator
on the display to determine if the rinse aid
available in your machine is adequate.
You shall add rinse aid to the rinse aid
compartment when the low rinse aid
warning indicator on the display starts to
illuminate.
Setting the Rinse aid Amount
1. When the door is closed, after
turning on your machine with the On/
Off button, enter the Sub-Menu by
pressing the On-Off and P2 program
buttons simultaneously for 3 seconds.
2. Go to "P" position on the display by
pressing the P2 button.
3. Set it to the appropriate
level by selecting one of the
"P:0","P:1","P:2","P:3" or "P:4" positions
with the P3 program button.
4. Exit the settings menu by pressing
the On/Off button for 3 seconds. Your
36/EN
settings will be saved automatically.
No rinse aid is applied in washing
program at P:0 position.
1 dose of rinse aid is applied at P:1
position.
2 dose of rinse aid is applied at P:2
position.
3 dose of rinse aid is applied at P:3
)
position.
4 dose of rinse aid is applied at P:4
position.
End of programme
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.
Water supply is cut-off warning
If the mains water supply is cut off or the
machine water inlet tab is not opened,
water would not flow into the machine and
the E:02 icon will flash on the program
indicator. As long as the error continues,
the washing program is stopped and it is
checked whether the water flows or not
into the machine at certain intervals, when
water flows in, the E:02 icon turns off after
a certain period of time and the washing
cycle resumes.
Advertisement
Table of Contents
