Trouble Shooting - Daewoo DWD-FU1081 Instruction Manual

TROUBLE SHOOTING

Most problems are easily solved if you understand the cause.
Check the following list for problem before calling for service.
If the error mode such as IE, OE, UE were displayed on the control part, in order to solve these
problem, first turn off the power of the washing machine and then turn on the power by rotating the
program selector.
If PFE error mode was displayed on the control part, in order to solve this problem, first turn off the
power of the washing machine, second turn on the power by rotating the program selector, third
select the SPIN program and last press Start/Hold button.
PROBLEM
• The washer will not
operate at all.
• Water is not supplied.
Error display
• The washer will not drain.
Error display
• The washer will not spin.
Error display
• The washer will stop
during spinning .
• Spinning is insufficient.
Error display
• Vibrating and too noisy.
These cases are not malfunctions;
• The sound "wing" heard during water supply is the operating sound made by the water inlet valve.
CHECK POINT
• Is there a power failure?
• Is the power cord correctly connected to an electric outlet?
• Did you turn on the power?
• Did you press Start/Hold button?
• Is there correct amount of laundry in the washer?
• Did you connect the inlet hose and open the water tap?
• Is the inlet hose or the water tap frozen?
• Is the water supply shut off?
• Is there any foreign matter blocking up the inlet hose filter?
• Is the drain hose frozen or blocked up by dirt?
• Is the drain hose kinked or deformed?
• Is the end of the drain hose immersed in water?
• Is there excessive dirt inside the drain filter?
• Is the clothes in the drum collected on one side?
• Is the washer installed on an uneven floor or is the vibration
serious?
• Is the door open? (The lamp "
• Is the filter of the drain pump clogged?
• Is the drain pump operated?
• Did you use the proper amount of detergent?
• Is the drain hose placed higher than 1m above floor?
• Is the washer installed on an uneven floor?
• Have all the transit bolts removed?
24
" will light up in this case.)