Pen Specifications And Recharge Note - ViewSonic ID2456 User Manual

Pen Specifications and Recharge Note

Item
Recharging
Requirement
Operating Hours
Down Button
Upper Button
Power Consumption
Pressure Levels
Power Saving Mode
Charging Port
Magnetic Function
LED Flash Mode
NOTE:
• For the first-time recharge of this Microsoft Pen Protocol (MPP) 2.0 pen, please use a
5V/1A recharge device with a USB Type A to Type C cable; do not charge for more than
4 hours to avoid battery damage.
• If a high power consumption charge device is used, it will cause battery damage.
• This Microsoft Pen Protocol (MPP) 2.0 pen does not support Power Delivery (PD)
Protocol.
• It is recommended to use a USB Type A to Type C cable and connect to the USB Type A
port of the ID2456 to charge the pen.
• The ID2456 display, with Microsoft Pen Protocol (MPP) 2.0, can detect when the pen
tip is near the screen.
InkView will be able to detect when the pen is close to the screen and visually show a
hovering cursor. If the pen tip is pressed, the pen signal transition state will be changed
from a hovering cursor to ink mode.
• Please note when using a silicone pen tip cover it will affect the pen's signal transition
state and always stay in ink mode. This may cause drawing or writing inaccuracies.
Charging voltage: 5V±5% , 4.75~5.25V
Charging current: 1A or less
Charging cable: Type A to Type C cable
Please do not charge for more than 4 hours to avoid battery
damage
When the battery is fully charged, being used 2 hours a day, it can
be used continuously for 50 days.
Standby
0.02mA
Yes, your pen will automatically enter power saving mode after
three (3) minutes. To wake, simply start writing.
Yes; only magnetic adsorption, not attraction charging function.
Charging
LED On
12
Specifications
Eraser Button
Primary Barrel Button
Hover
0.15mA
4096 levels
USB Type C
Charging Complete
LED Off
Working
(Tip on)
0.28mA
Low Battery
LED Flash