Connecting The Drain Line - LG WM9000HWA Owner's Manual

Connecting the drain line

secure the drain hose in place to prevent moving
and leaking.
NOTE
y the drain hose should be properly secured.
failure to properly secure the drain hose can
result in flooding and malfunction.
y total height of the house end should not exceed
96 inches (244.8 cm) from the bottom of the
washer.
y the drain must be installed in accordance with
any applicable local codes and regulations.
y make sure that the water lines are not stretched,
pinched, crushed, or kinked.
Using a standpipe
1
clip the end of the hose into the elbow bracket.
- connect the elbow bracket within 4 inches (10
cm) from the end of the drain hose. if the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold or
microorganisms could spread to the inside of
the washer.
Elbow bracket
2
insert the end of the drain hose into the
standpipe.
3
use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain hose
INSTALLATION INSTRUCTIONS
Using a laundry tub
1
clip the end of the hose into the elbow bracket.
- connect the elbow bracket within 4 inches (10
cm) from the end of the drain hose. if the drain
hose is extended more than 4 inches (10 cm)
beyond the end of the elbow bracket, mold, or
microorganisms could spread to the inside of
the washer.
Elbow bracket
2
hang the end of the drain hose over the side of
the laundry tub.
3
use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain hose
17