Husqvarna QRT4681W User Manual page 20

20 www.husqvarna-electrolux.se
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
Some specific surfaces in‐
side the fridge compartment
are warmer at some times.
Temperature setting LEDs
flash at the same time.
Possible cause
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The "FROSTMATIC func‐
tion" is switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The FROSTMATIC function
is switched on.
There is no cold air circula‐
tion in the appliance.
An error has occurred in
measuring the temperature.
Solution
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FROSTMATIC
function" manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to "FROST‐
MATIC function" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "FROSTMATIC
function" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
This is a normal state.
Contact the nearest Author‐
ised Service Centre. The
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible.