Camera Programming - Stealth Cam STC-PX18CMO Instruction Manual

This PX18CMO features 6 distinct modes of operation:
OFF / QSET1 / QSET2 / QSET3 / CUSTOM / TEST. Each
setting is activated based upon the position of the
program dial on the inside of the unit.
OFF – This position completely powers down the unit.
QSET1 – This is the first Quick Set programming mode.
When the camera is changed to this mode, the display screen will give a digital read out of the
following:
With this setting the camera is preprogrammed to take photos at 4MP resolutions, a 30 second
timeout delay between activations and takes a burst of 3 photos every trigger activation.
QSET2 – This is the second Quick Set programming mode. This setting is preprogrammed to take
photos as 4MP resolution, 30-­‐second timeout delay and take a single photo per trigger activation.
QSET3 – This is the third Quick Set programming mode. This setting is preprogrammed to take a
VGA Video, have a 30 second timeout delay between activations, and each video will be 10
seconds in length.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING
st
1 -­‐ dLY 30 – (Delay) Counts down from 30sec to 0sec
nd
2 -­‐ rdY – (Ready) Camera is in a ready and active state
Page
7