Table of Contents
Advertisement
Figure 25. Installing the air shroud
Next steps
1.
Install the system
cover.
2. Follow the procedure listed in
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Keep the plastic scribe ready.
Steps
1. Disconnect the intrusion switch cable connector from the system board.
NOTE:
Observe the routing of the cable as you remove it from the system. Route the cable properly when you
replace it to prevent the cable from being pinched or crimped.
2. Using the plastic scribe, slide the intrusion switch out of the intrusion switch slot.
50
Installing and removing system components
Before working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
