Installing The Device On A Din Rail - D-Link NUCLIAS CONNECT DIS-2650AP User Manual

Basic Installation

Installing the Device on a DIN Rail

The DIS-2650AP can be mounted on a standard DIN rail using the included DIN mounting kit.
Use the following instructions to install the DIS-2650AP on a rail:
1. Check that the DIN rail is installed properly using at least two screws on each end.
2. Fasten the DIN mounting clip to the rear panel of the device using the included mounting screws.
3. Position the DIS-2650AP against the rail, then tilt it upwards and hook the DIN rail clip on the back of the device against the rail. Snap the device
into place to complete the installation.
9