Table of Contents
Advertisement
Connecting to a hob
en
Saturation display
If the metal grease filters or the activated charcoal filter
are/is saturated, the corresponding symbols flashes
after the appliance is switched off:
Metal grease filters:
■
Activated charcoal filter:
■
Metal grease filters and activated charcoal filter:
■
and
"
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 13
The saturation indicator does not apply for non-
Note:
renewable activated charcoal filters that are inserted
downstream of the metal grease filter. These activated
charcoal filters must be replaced twice a year.
The saturation indicators can be reset while they are
flashing. To do this, touch the
same time.
Switching over the display for air circulation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
#
■
time until "2" lights up for air recirculation mode
(filters that cannot be regenerated).
Touch and hold the
#
■
same time until "3" lights up for air recirculation
mode (filters that can be regenerated).
Touch and hold the
#
■
same time until the electronic controller has
switched back to air extraction mode (indicator 1 ).
Audible signal
Switching on
With the fan switched off, touch and hold the
symbols at the same time for approximately 3 seconds.
A signal will sound as an acknowledgement.
When the signal tone is activated,
Switching off
With the fan switched off, touch and hold the
symbols at the same time for approximately 3 seconds.
A signal will sound as an acknowledgement.
When the signal tone is deactivated,
10
!
"
and
symbols at the
#
A
and
symbols at the same
@
and
symbols again at the
@
and
symbols again at the
@
#
will be lit.
‚
#
will be lit.
‹
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
eConnecting to a hob
Y ou can connect this appliance to a hob (if the hob
C o n n e c t i n g t o a h o b
supports connection to the appliance) and then control
the functions of the hood via your hob.
Appliances can be connected to each other in different
ways:
!
Home Connect
Two appliances can be connected using the Home
Connect app provided that both of them are Home
Connect compatible.
Refer to the Home Connect documents supplied for
more information.
Connecting appliances directly
If the appliance is connected directly to a hob, it cannot
be connected to your home network as well. The
appliance will function as an extractor hood that is not
connected to the network and you can continue to
operate it via the control panel.
and
&
and
&
Advertisement
Table of Contents
