4 Voice Recognition
Using Voice Recognition
Starting Voice Recognition
Starting Voice Recognition
Shortly press the [VR] key on the steering
remote controller ▶Say a command
If voice recognition is in [Normal Mode],
then the system will say "Please say a
command. Beep~"
• If voice recognition is in [Expert Mode],
then the system will only say a "Beep~"
• To change the Normal Mode/Expert
Mode setting, go to [SETUP] ▶ [System]
▶ [Prompt Feedback].
Information
• For proper recognition, say the
command after the voice instruction and
beep tone.
Skipping Prompt Messages
While prompt message is being stated▶
Shortly press the [VR] key on the steering
remote controller (under 0.8 seconds)
The prompt message is immediately
ended and the beep tone will sound. After
the "beep", say the voice command.
Re-starting Voice Recognition
While system waits for a command ▶
Shortly press the [VR] key on the steering
remote controller (under 0.8 seconds)
The command wait state is immediately
ended and the beep ton will sound. After
the "beep", say the voice command.