Table of Contents
Advertisement
Other Features
TV Status
Programme
Number,
Sound Indicator and Zoom Mode are displayed
on the screen when a new programme is entered or
.
button is pressed
Mute Indicator
It is placed in the upper side of the screen when
enabled.
To cancel mute, there are two alternatives; the first
one is pressing the
button and the second one is
increasing the volume level.
PIP and PAP modes
Press the
button to switch to PIP mode.
At PIP Mode, a small picture (PIP picture) is displayed
on the main picture. Aspect Ratio of the PIP window is
fixed and 4:3.
When PIP Mode is entered, the default active window
is PIP window and the active window is indicated by
a white frame around it. The active window can be
_
changed by pressing
OSD belongs to active window. The place of the sta-
tus OSDs are same for both windows.
Press the
button again to switch PAP mode.
At PAP Mode, two pictures with equal sizes are dis-
played on the screen. Aspect Ratios of the windows
are fixed.
When you switch to PAP Mode, Main window in PIP
Mode is displayed on the right side of the screen. The
active window can be changed by pressing
button.
Press the
button again to exit the PAP mode.
NOTE: In all HDMI modes, Pip and PAP are not vis-
ible. In YPbPr 1080i , Pip is not visible.
NOTE: See Appendix C for all PIP/PAT modes.
PAT
In PAT (Picture and Text) mode, picture is splitted into
two and text is displayed near the main picture.
There are two ways available for switching to PAT
mode:
• Pressing
button while in teletext will switch the
TV to PAT mode.
Programme
Name,
`
/
button. The status info
_
English - 27 -
• While the PAP function is off, pressing
switch the TV to PAT mode.
AV Modes
You can switch your TV to AV modes by using re-
lated buttons on the remote control.
First, press
on the screen. You can then use; AV1, AV2, AV3,
AV4, AV5, HDMI1 or HDMI2 buttons on your remote
control to select the desired source (except being in
teletext).
Note that in PIP/PAP modes, pressing
will directly change sources.
Freeze Picture
You can freeze the picture on the screen by pressing
the
button on the remote controller. At PIP and
PAP layouts, only the main picture can be frozen.
Zoom Modes
Zoom mode can be changed by pressing the “
Aspect ratio” button. You can change the screen
size according to the picture aspect ratio. Select the
optimum one from the following ZOOM modes.
NOTE: InYPBPR and HDMI modes,while in 720 and
1080 resolutions, Full 1 and Full 2 modes
will be visible.
NOTE: When in “Full 1” mode; if picture defects in
top and bottom lines occur because of the
broadcast, switch to “Full 2” mode to avoid. If
such defects in the edges of picture are not
experienced, it is advised that you watch in
“Full 1” mode.
NOTE: You can only choose 4:3 and FULL in PC
mode.
Auto:
When a WSS (Wide Screen Signalling) signal,
`
/
which shows the aspect ratio of the picture, is in-
cluded in the broadcast signal or the signal from an
external device, the TV automatically changes the
ZOOM mode according to the WSS signal.
• When the AUTO mode does not function correctly
due to poor WSS signal quality or when you want to
change the ZOOM mode, change to another ZOOM
mode manually.
button till INPUT OSD is displayed
twice will
button
Advertisement
Table of Contents
