Microphone Operation; Resume Factory Default - Alinco DR-MD520T Instruction Manual

MICROPHONE OPERAtION

DOWN
PTT
Main/Sub band switch
You can operate the transceiver by keypad or input desired frequency
and channel through the EMS-88 microphone.
Send DtMF signaling
Hold the [PTT] key; input the desired DTMF signaling by the numeric
keys.
Main/Sub band switching
At the default setting, both MAIN and SUB bands are displayed. The
transmitting is possible only on the frequency/channel.
To switch main / sub band, press the [M/S] or [P1] key to set the desired
frequency or channel.
MIC
UP
Numeric Keys
Microphone speaker
EMS-88
Microphone Operation

RESUME FACtORY DEFAULt

If your transceiver seems to be malfunctioning becuase of wrong
operation or setup, this function will be able to resume all setup and
channels to factory default.
Press and hold [P2] Key + CH knob + Power key at the same time to
power on the transceiver.
The transceiver will start up with a note on the display "Are you sure you
want to initialize radio?"
Press [Menu] Key to proceed the reset, on the screen displays "Initialize
Radio" Then radio will resume to factory default setting status.
(Channel A: 155MHz, Channel B: 456MHz)
Reset function may be prohibited by PC programming. The memory
channels will be erased and can't recall after reset.
4
10