Compaq 486 Maintenance And Service Manual page 79

1. Remove the keyboard (Section 5.5).
2. Remove the front bezel (Section 5.14).
3. Remove the display assembly (Section 5.14).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The display inverter board contains high voltage.
surfaces of the board.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
When removing or inserting cables with ZIF connectors, do not pull, twist, or
apply tension to cables.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
NOTE: The ZIF connectors in this product have mechanical latches that either
slide forward and lift up or slide up to open.
ZIF connectors are opened before attempting to remove the cable.
4. Carefully disconnect the power distribution board cable from the ZIF
connector on the display inverter board (Figure 5-23).
5. Carefully disconnect two cables from the display assembly (Figure 5-23).
WARNING
Avoid contact with all
CAUTION
Be sure the latches on the