System Configuration Menu - HP Compaq 2230s Maintenance And Service Manual

System Configuration menu

✎
Some of the listed System Configuration options in this section may not be supported by your computer.
Select
Language
Boot Options
Device Configurations
Computer Setup
To do this
Change the Computer Setup language.
■ Set a Startup Menu delay (in seconds).
■ Enable/disable Custom Logo (disabled by default).
■ Enable/disable Display Diagnostic URL (enabled by default).
■ Enable/disable CD-ROM boot (enabled by default).
■ Enable/disable SD Card boot (enabled by default).
■ Enable/disable floppy boot (enabled by default).
■ Enable/disable PXE Internal NIC boot (enabled by default).
■ Set the Express Boot Popup delay in seconds.
■ Set the boot order.
■ Enable/disable USB legacy support (enabled by default). When enabled,
USB legacy support allows the following:
❐ Use of a USB keyboard in Computer Setup even when a Windows®
operating system is not running.
❐ Startup from bootable USB devices, including a hard drive, diskette drive,
or optical drive connected by a USB port to the computer.
■ Select a parallel port mode: ECP (Enhanced Capabilities Port), standard,
bidirectional, or EPP (Enhanced Parallel Port).
■ Enable/disable fan always on while connected to an AC outlet (enabled
by default).
■ Enable/disable LAN Power Save (select models only). When enabled, saves
power by turning off the LAN when not in use (enabled by default).
■ Enable/disable Data Execution Prevention. When enabled, the processor can
disable some virus code execution, which helps to improve computer security.
■ SATA (Serial Advanced Technology Attachment) device mode. The following
options are available:
❐ AHCI (Advanced Host Controller Interface)
❐ IDE (Integrated Drive Electronics)
❐ RAID (select models only)
✎
Availability of the options above varies by computer model.
■ Enable/disable secondary battery fast charge (enabled by default).
■ Enable/disable HP QuickLook 2 (enabled by default).
■ Enable/disable Virtualization Technology (select models only; disabled
by default).
■ Enable/disable TXT (Intel® Trusted Execution Technology) (select models
only; disabled by default).
■ Enable/disable Dual Core CPU (select models only; enabled by default).
■ Enable/Disable Unified Extensible Firmware Interface (UEFI) mode (disabled
by default).
(Continued)
5–4