Step 7 Placing The Dishwasher And Connecting The Hot Water Supply Line - Samsung DW80R5060 Series Installation Manual

installing the dishwasher
STEP 7 PLACING THE DISHWASHER AND CONNECTING THE HOT
WATER SUPPLY LINE
1. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height
of the cabinet opening from under the countertop to the fl oor. (See Step 8, Leveling the
Dishwasher.)
2. Locate the hot water supply line and the power cable.
3. Place the dishwasher so that the power cable is in the right channel of the base of the
dishwasher. Use standard duct tape or cable ties to secure the electrical cable to their
adjacent channels in the base. This can prevent the electrical cable from being squeezed
when you push the the dishwasher into place.
4. Pull the drain hose through the hole in the sink cabinet side wall. Keep it free of kinks.
5. Make sure the hot water supply line is not twisted, and then connect the hot water supply
line to the elbow joint.
6. Slide the dishwasher carefully into the installation space. If possible, gently pull any excess
lengths of water supply line, drain hose, or power cable back as you move the dishwasher.
Get a second or third person to help you do this if necessary.
Do not place the dishwasher on the water supply line, drain hose, or power cable.
Also, make sure they are not folded or twisted.
CAUTION
<Figure 6>
14_ installing the dishwasher
Installation_DD81-02034B-02_EN.indd Sec3:14 Installation_DD81-02034B-0 _EN.indd Sec3:14 2
Drain hose Drain hose
Hot Water Supply Line Hot Water Supply Line
<Figure 7>
Hot Water Supply Line Hot Water Supply Line
Elbow( 3/4" (9.5 mm)) Elbow( 3/4" (9.5 mm))
Inlet valve Inlet valve
CAUTION
Do not overtighten the 90˚ Fitting.
(Below 280 lb·in (31.6 N·m))
Doing so may damage the water inlet
valve and cause a water leak.
25 5 /08/2017 10:56:03 AM /10/2016 10:56:03 AM