MSI H270-A Manual page 45

fDevice Mode [STD Printer Mode]
Selects an operating mode for parallel port.
[STD Printer Mode]
[SPP]
[EPP-1.9/ 1.7 + SPP]
[ECP]
[ECP + EPP-1.9/ 1.7]
Power Management Setup
f
Sets system Power Management of EuP2013 and AC Power Loss behaviors. Press
Enter to enter the sub-menu.
fEuP 2013 [Disabled]
Enables or disables the system power consumption according to EuP2013
regulation.
[Enabled] Optimize the system power consumption according to EuP 2013
regulation. It will not support S4 & S5 wake up by USB, PCI and PCIe
devices.
[Disabled] Disables this function.
fRestore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power Off] Leaves the system in power off state after restoring AC power.
[Power On] Boot up the system after restoring AC power.
[Last State] Restores the system to the previous state (power on/ power off)
before AC power loss.
fSystem Power Fault Protection [Disabled]
Enables or disables the system to boot up when detecting abnormal voltage input.
[Enabled] Protect the system from unexpected power operation and remain
the shut down status.
[Disabled] Disables this function.
Windows OS Configuration
f
Sets Windows OS detailed configuration and behaviors. Press Enter to enter the sub-
menu.
fWindows 8.1/ 10 WHQL Support [Disabled]
Enables the supports for Windows 8.1/ 10 or disables for other operating systems.
Before enabling this item, make sure all installed devices & utilities (hardware &
software) should meet the Windows 8.1/ 10 requirements.
[Enabled] The system will switch to UEFI mode to meet the Windows
equirement.
[Disabled] Disables this function.
Printer port mode
Standard Parallel Port mode
Enhanced Parallel Port-1.9/ 1.7 mode + Standard
Parallel Port mode.
Extended Capability Port mode
Extended Capability Port mode + Enhanced Parallel
Port-1.9/ 1.7 mode.
45
BIOS Setup