Table of Contents
Advertisement
Installation Instructions - Standard Installation
STEP 9 INSTALL FRAMED PANELS
Install Door Panel:
• Open the door to 90°. Remove the 6 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 6 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the framed panel into the door trim.
Right hand models shown. Use the same instructions
for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 10A.
Use Front Holes
to Secure Trim
Use Rear Holes
to Secure Handle
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
19
Handle
Door Trim
Trim
Door
Standard supplied handle shown
in 1/4" panel position.
Advertisement
Table of Contents
