Section 3: Operations; Operation Safety; Attaching The Fretboard - Grizzly G0577 Instruction Manual

SECTION 3: OPERATIONS

Operation Safety

Damage to your eyes, lungs, and ears could
result from using this attachment without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this attachment.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
NOTICE
If you have never used this type of attach-
ment or equipment before, WE STRONGLY
RECOMMEND that you read books, trade
magazines, or get formal training before
beginning any projects. Regardless of the
content in this section, Grizzly Industrial
will not be held liable for accidents caused
by lack of training.
-10-
Attaching the
Fretboard
There are several methods of attaching the
fretboard to the radiusing attachment. These
include screws, double stick tape, friction pins,
clamping, or a vacuum system. These instruc-
tions only cover attaching the fretboard with
double stick tape.
To attach the fretboard to the radiusing attach-
ment:
1.
Use a jointer to flatten the back of the
fretboard.
2. Mark a line down the center of the back of
the fretboard.
Note—This center line is important. If it is off
center, the radius of the fretboard will be off
center.
3.
Place a strip of double stick tape on either
side of the holes in the swing arm crossbar.
Note—Only use high quality, film type, dou-
ble stick tape. Reinforced and foam backed
double stick tape will not hold the fretboard
securely.
4. Line up the swing arm crossbar holes with
the center line on the fretboard and carefully
stick the fretboard to the crossbar.
5. When finished radiusing the fretboard,
remove the tape residue from the crossbar
with WD-40 , or an oil, such as gun oil.
®
6. Clean off the oil residue with lacquer thinner
or an alcohol based solvent.
G0577 Fretboard Radiusing Attachment