Home Standby Remote Start Kit
Model No. G0071090
Purpose
This kit enables activation of a remote start feature. The remote start feature exists on ALL home standby
generators with a controller fitted with an LCD screen. Units without an LCD screen do NOT have remote start
capability, except for the PowerPact™ generators.
EcoGen™ units are equipped with two wire start, so this kit is not required. CorePower™ units do not have an
NOTE:
LCD screen on the controller, so the kit is not applicable. This kit should not be used with off-grid applications—doing
so could void the warranty.
The feature is contained within the LCD screen units and is enabled via a password. The option to enable remote start
is found under the Edit menu. This menu allows the ability to scroll through various parameters and change them. Once
they are changed, they will be remembered even when the power is removed.
Remote Starter Kit Contents
Part Number
Wire Color
0J0973A
White
0J0973C
0J0973D
Dark Blue
0J0973E
The kits contain different wire types, based on the mating connector lugs. Some kits contain spare wires.
NOTE:
Evolution Controllers
Turn utility MLCB to OFF or Open.
1.
Unlock and open the generator lid.
2.
Turn the generator switch to the OFF mode.
3.
Remove the 7.5 Amp fuse from the top of the control panel.
4.
Remove the generator front panel.
5.
Disconnect the negative (-) black lead from the generator battery.
6.
The exercise function will need to be reset every time the 12 volt battery and T1 power to the generator are
NOTE:
disconnected and then reconnected, and/or when the fuse is removed and T1 power is removed from the generator.
Instruction Sheet
INSTRUCTION SHEET
Quantity
3
1 each
Used With
Evolution™ Controllers
PowerPact™ Controller
®
1